-
6.
Will RockSolid HOME adhere to caulk?
RockSolid HOME will adhere to any non-silicone, paintable caulk, such as DAP Kwik Dry. However, it's recommended that you apply RockSolid HOME prior to any caulking. If silicone caulk is present ,we suggest removing it before painting. Any generic caulk brand can be applied AFTER floor is coated with RockSolid HOME.
-
7.
Can RockSolid HOME be used on waxed floors?
No. Wax needs to be removed before applying the coating.
-
8.
How do I clean my floor after it has been coated with RockSolid HOME Interior Floor Coating System?
A fully cured floor can be cleaned with mild soap and water after 7 days. Do not use an abrasive cleaner.
-
9.
Can RockSolid HOME be used on vertical surfaces?
RockSolid HOME is recommended for horizontal surfaces. It can be used on short vertical surfaces, such as a tile baseboard as an extension of the floor, but we recommend the Top Coat be applied with a brush in that case.
-
10.
How do I test a small area of my floor before applying RockSolid HOME?
All flooring should be tested for adhesion before coating the entire floor. Clean a small 3”x3” inconspicuous area, let dry. Apply Base Coat over area and allow to dry for 12 hours. Using a utility knife, make an X in the coating down to the flooring. Apply a 4” piece of duct tape over the X and press firmly. Remove the tape with one quick pull. If more than 10% of the coating comes off, the floor will need to be sanded with 60-80 grit sand paper before coating the entire floor.