Rust-Oleum Projects

Spruce up your foundation & protect it from seepage

Browse Projects

  • Rusty bistro table makeover
    Rusty Bistro Table Makeover
  • Wooden crate stained with Varathane Fast Dry Wood Stain in Worn Navy and finished with Varathane Triple Thick Polyurethane.
    Stained Navy Wooden Crate
Seal Krete Waterproof your basement After
  • Estimated Time

    1 Day

  • Challenge Level


  • Tools & Supplies:

    • Bleach (if needed to remove mold & mildew)
    • Wire brush, muriatic acid & baking soda (if needed to remove efflorescence)
    • Fast-Setting Hydraulic Cement or Concrete Crack Filler (to repair surface breaks)
    • Gloves & safety glasses (recommended)
    • Stir Stick
    • Paint roller (½” - ¾” nap roller cover)
    • High quality nylon-polyester brush

The exterior of your home can look even better with a spruced up foundation. SEAL-KRETE DampLock Masonry Waterproofing Paint stops 15psi and looks great at the same time.

Step 1 Prep & Prime:
Proper surface preparation is critical to the success of all SEAL-KRETE coatings.

SURFACE PREP: New concrete must have cured for a minimum of 30 days. The surface should be clean, sound and free of dirt, dust, oil, wax and grease. DampLock may be used on painted surfaces to improve water resistance; however, surface must be bare concrete for waterproofing. Cleaning: Remove mold/mildew with a solution of 1 part bleach, 3 parts water. Rinse and let dry. Remove efflorescence with a wire brush and solution of 1 part muriatic acid, 9 parts water. Neutralize acid with a solution of baking soda and water (i.e., 1 lb. baking soda, 5 gallons of water). Rinse thoroughly: let dry. Repairs: Repair surface breaks around wall/floor joints and patch cracks with fast-setting hydraulic cement or concrete crack filler, using trowel to smooth patch to surrounding area.

Step 2 Apply Paint:
SEAL-KRETE DampLock comes as a tint base or premixed in white. It can be tinted to 10 additional colors.  This product is ready to use; do not dilute. Stir thoroughly before (and occasionally during) use. DampLock may be applied to a damp surface; however, application to a dry surface provides best results. Apply first coat with a ½” to ¾” nap roller cover or high quality, nylon-polyester brush. Use a brush to work paint into the grout lines. Allow to dry 3 hours, then apply second coat. 2 coats are recommended for waterproofing and are required for any warranty claims.

note: If leak occurs after applying 2 coats, pin holes may be present. Paint these areas again, using a brush to work paint into the pores.

Dries in 2-3 hours, depending on temperature and humidity. Wait 24 hours before topcoating with latex/acrylic paint, if desired.