All Project

Refresh your concrete front porch


A beautiful porch adds instant curb appeal to your home and is inviting for guests. SEAL-KRETE Floor-Tex Textured Coating is a durable textured coating for patios and porches that looks as good as it works.

Step 1 Prep & Prime:
Proper surface preparation is critical to the success of all SEAL-KRETE coatings. The surface should be clean, dry, sound and free of dirt, dust, oil, wax and grease. You may need an oil stain remover such as Krud Kutter Oil Grabber to lift stubborn oil stains.

Bare Concrete: Concrete must have cured for a minimum of 30 days before application. Etch the surface with SEAL-KRETE Clean-N-Etch to allow for proper penetration and adhesion. Etching is especially important for smooth-troweled concrete surfaces and is also recommended for rough finished surfaces. After etching, rinse thoroughly and let dry. For best results apply one thin coat of SEALKRETE Lock-Down Concrete Bonding Primer.

Surface Cracks: Use a paintable acrylic or urethane caulk to repair hairline cracks. For other cracks (up to 3/8” wide) use a flexible, acrylic concrete patch or filler. Let all materials cure fully.

Previously Stained or Painted Concrete:
For use over one-part water-based coatings only; not recommended over oil-based coatings. Remove loose or peeling paint and degloss surface by sanding (150–200 grit sandpaper).* Follow with a general cleaning. Rinse thoroughly and let dry. Then coat the surface with SEALKRETE Lock-Down Concrete Bonding Primer.

Step 2 Apply Paint:
SEAL-KRETE Floor-Tex Textured Concrete Coating is ready to use; do not dilute. Use only when air and surface temperatures are 50° to 90°F (10° to 32°C). A minimum of 2 coats is recommended. Apply first coat and let dry to touch, then apply second coat in a direction perpendicular to the first.

Brush: Use a high quality, nylon bristle brush.

Roller: Use a short nap (1/8”, 3/16” or 1/4”) cover – synthetic or mohair blend.

Step 3 Protect Your Investment:
For added protection and durability, apply a high quality clear acrylic finish such as SEAL-KRETE Clear-Seal – available in both satin and gloss sheens.

Floor-Tex Coverage: 60 sq. ft. per gallon

Clean occasionally with a mild soap and water solution. Do not use solvent, citrus or oil-based cleaners. If needed, scrub surface with a soft bristle brush or shop broom. Rinse with a garden hose or power washer (less than 1200 psi) held at least 18 inches from the surface, using a fan spray pattern. Re-apply sealer every 2 years, or as needed. 

Other Materials:

  • Paint roller or nylon-polyester brush
  • Safety Goggles
  • Rubber Gloves
  • Stiff-bristled broom
  • Pump sprayer or watering can
  • Garden hose with spray attachment

Locate a Rust-Oleum Retailer

Rust-Oleum products are sold at retailers across the country. Use our store locator to find Rust-Oleum products at retailers near you.