Rust-Oleum Projects

Give Your Garage a Showroom Finish

Browse Projects

  • Give your Flooring a Modern Refresh with RockSolid Marble
    Give your Flooring a Modern Refresh with RockSolid Marble
  • Brake caliper painted with Rust-Oleum Caliper Paint
    How to Paint Your Brake Calipers

If you spend a lot of time in your garage, you don’t want a grimy, dirty floor. SEAL-KRETE Epoxy-Seal Concrete and Garage Floor paint with a flake finish and clear sealer can easily transform your space into a showplace that’s durable and easy to clean.

Step 1: Prep & Prime
Proper surface preparation is critical to the success of all SEAL-KRETE coatings. The surface should be clean, dry, sound and free of dirt, dust, oil, wax and grease. You may need an oil stain remover such as Krud Kutter Oil Grabber to lift stubborn oil stains.

Bare Concrete: Concrete must have cured for a minimum of 30 days before application. Etch the surface with SEAL-KRETE Clean-N-Etch to allow for proper penetration and adhesion. Etching is especially important for smooth-troweled concrete surfaces (like carports, garage and basement floors) and is also recommended for rough-finished surfaces. After etching, rinse the surface thoroughly and let dry. For best adhesion results, apply one thin coat of SEAL-KRETE Lock-Down™ Concrete Bonding Primer.

Previously Stained Or Painted Concrete: For use over one-part water-based coatings only; not recommended over oil-based coatings. Remove loose or peeling paint and degloss surface by sanding (150–200 grit paper).Follow with a general cleaning. Rinse thoroughly and let dry. Then coat the surface with SEAL-KRETE Lock-Down Concrete Bonding Primer.

Step 2: Apply Paint
SEAL-KRETE Epoxy Seal comes as a tint base or premixed in light or dark gray. It can be tinted to 38 different colors.  This product is ready to use; do not dilute. Use only when air and surface temperatures are 55° to 90°F (13° to 32°C). Additional dry time is needed in lower temperatures or when relative humidity is more than 50%.

If more than one gallon is used, intermix all product to ensure color uniformity; stir well. Apply a very thin coat with a roller** or nylon-polyester brush. Wait 4–6 hours. Working in small (5’x5’) sections, apply second coat of EPOXY-SEAL perpendicular to the first; immediately sprinkle flakes onto wet paint. ** Use 1/4” nap for smooth-troweled surface, 3/8” nap for broom-finished surface, 1/2” nap for rough or textured surface.

Step 3: Protect Your Investment
For added protection and durability, apply a high quality clear acrylic finish such as SEAL-KRETE Clear-Seal – available in both satin and gloss sheens.

Epoxy-Seal Coverage: 300-500 sq. ft. per gallon

An average 2-car garage will require approximately:

Three gallons of SEAL-KRETE Epoxy-Seal
Two gallons Clean-N-Etch
1/2 gallon Oil Stain Remover

Allow 30 days before cleaning surface. Do not use abrasive cleaners or pressure washers on surface.